Quick Reference Guide

CMC Property Database Group and Object Definitions 133
cfgSerialHistorySize=8192
cfgSerialTelnetEnable=0
cfgSerialSshEnable=1
cfgNetTuning
NOTE: Use this object with the config or getconfig subcommands.
NOTE: To use this object property, you must have Chassis Configuration
Administrator privilege.
Description
Displays and configures CMC network tuning parameters.
cfgNetTuningNicSpeed
Specifies the speed for the CMC NIC. This property is used only if
cfgNetTuningNicAutoNeg is set to 0 (disabled).
• Configuration options: 10 or 100
•
Default: 100
cfgNetTuningNicFullDuplex
Specifies the duplex setting for the CMC NIC. This property is used only if
cfgNetTuningNicAutoNeg is set to 0 (disabled).
• Configuration options: 0 (half duplex), 1 (full duplex)
•
Default: 1
cfgNetTuningNicMtu
Specifies the size in bytes of the maximum transmission unit used by the
CMC NIC. The minimum transmission unit size for IPv6 is 1280. If
cfgNetTuningNicMtu is less than 1280, the CMC assigns 1280 as the value
of the NIC if IPv6 is enabled.
• Configuration range: 576–1500
•
Default: 1500
NOTE: IPv6 requires a minimum MTU of 1280. If IPv6 is enabled, and
cfgNetTuningMtu is set to a lower value, the CMC uses an MTU of 1280.