Owner's Manual

file:///T|/htdocs/SOFTWARE/smdrac3/cmc/cmc2_10/en/readme/readme.TXT[10/26/2012 2:25:55 PM]
No known issues for this release.
#####################################################################
KNOWN ISSUES FOR DOCUMENTATION
#####################################################################
No known issues for this release.
#####################################################################
FLEXADDRESS
#####################################################################
Required Module Firmware to use the Chassis FlexAddress feature with CMC 2.10:
----------------------------------------------------------------
Component | Required version
----------------------------------------------------------------
Ethernet Mezzanine card - | Firmware 4.4.1,
Broadcom M5708t/M5708is,M5708 | iSCSI boot firmware 2.7.11,
| PXE firmware 4.4.3
----------------------------------------------------------------
FC Mezzanine card - | BIOS 2.04 or later
QLogic QME2472
----------------------------------------------------------------
FC Mezzanine card - | BIOS 3.03a3 and firmware 2.72A2
Emulex LPe1105-M4
----------------------------------------------------------------
Blade Server BIOS | (PE M600) BIOS 2.1.4 or later
| (PE M605) BIOS 4.02 or later
| (PE M805) 1.1.2 or later
| (PE M905) 1.1.2 or later
| (PE M610) All BIOS versions
| (PE M710) All BIOS versions
----------------------------------------------------------------
iDRAC | Firmware 1.50 or later(PE M600,
| PE M605, PE M805, PE M905)
| or Firmware 2.10 or later(PE M610, PE M710)
----------------------------------------------------------------
CMC | Firmware 2.10
----------------------------------------------------------------
* FlexAddress: Prior to inserting the SD card into the CMC, verify the write
protection latch is in the "unlock" position.
The FlexAddress feature cannot be activated if the SD card is write-
protected.
* FlexAddress: The system BIOS must be upgraded prior to installing
FlexAddress. If not, a warning icon is displayed on the
server health page. Once the system BIOS is updated, the modular
server must be power cycled before the FlexAddress chassis-assigned
MAC addresses are accepted by the modular server. The CMC
displays that chassis-assigned MACs are configured but the server will
use the server-assigned MAC configuration.
* FlexAddress: If you issue a CMCCHANGEOVER or RACRESET and then log
into the CMC Web GUI, the FlexAddress Web page may take up
to a minute to update the switch configurations.