User's Manual

66 Using the RACADM Command Line Interface
connect Connects to the serial console of a server or I/O module.
See "Connecting to Servers or I/O Modules With the
Connect Command" on page 59 for help using the
connect subcommand
config Configures the CMC.
deploy Deploys a server by specifying required properties.
feature Displays active features and feature deactivation.
featurecard Displays feature card status information.
fwupdate Performs system component firmware updates, and
displays firmware update status.
getassettag Displays the asset tag for the chassis.
getchassisname Displays the name of the chassis.
getconfig Displays the current CMC configuration properties.
getdcinfo Displays general I/O module and daughter card
misconfiguration information.
getflexaddr Displays the FlexAddress enabled/disabled status on a per
slot/fabric basis. If used with the -i option, the command
displays the WWN and MAC address for a particular slot.
getioinfo Displays general I/O module information.
getkvminfo Displays information about the iKVM.
getled Displays the LED settings on a module.
getmacaddress Displays a server’s MAC address.
getmodinfo Displays module configuration and status information.
getniccfg Displays the current IP configuration for the controller.
getpbinfo Displays power budget status information.
getraclog Displays the CMC log.
getractime Displays the CMC time.
getredundancymode Displays the redundancy mode of the CMC.
getsel Displays the system event log (hardware log).
Table 4-1. RACADM Subcommands (continued)
Command Description