User's Manual

Installing and Setting Up the CMC 41
d On the Enclosure screen, to apply all enclosure settings highlight the
Accept/Yes icon and press the center button. To not apply the
enclosure settings, highlight the
No icon and press the center button.
9 On the IP Summary screen, review the IP addresses you provided to make
sure the addresses are accurate. To correct a setting, navigate to the left
arrow button and then press the center key to return to the screen for that
setting. After making a correction, press the center button. If necessary,
navigate to the right arrow button and then press the center key to return
to the
IP Summary screen.
When you have confirmed that the settings you entered are accurate, press
the center button. The Configuration Wizard closes and returns you to the
Main Menu screen.
The CMC and iDRAC are now available on the network. You can access the
CMC on the assigned IP address using the Web interface or CLIs such as a
serial console, Telnet, and SSH.
NOTE: After you have completed network setup through the LCD Configuration
Wizard, the Wizard is no longer available.
Accessing the CMC Through a Network
After you have configured the CMC network settings, you can remotely
access the CMC using any of the following interfaces:
• Web interface
• Telnet console
• SSH
• Remote RACADM
Telnet is enabled via one of the other interfaces; telnet is not as secure as the
other interfaces so it is disabled by default.