User's Manual

Troubleshooting and Recovery 323
Name Displays the name of the server in each slot.
Present Displays whether the server is present in the slot (Yes or No).
Health OK The server is present and communicating with
the CMC. In the event of a communication
failure between the CMC and the server, the
CMC cannot obtain or display health status
for the server.
Informational Displays information about the server when
there is no change in health status (OK,
Warning, Severe).
Warning Warning alerts have been issued, and
corrective action must be taken within the
time frame set by the administrator. If
corrective actions are not taken within the
administrator-specified time, critical or severe
failures that can affect the integrity of the
server can occur.
Severe At least one failure alert has been issued.
Severe status represents a CMC system failure,
and corrective action must be taken
immediately.
iDRAC Status Displays the status of the server iDRAC embedded management
controller:
• N/A - Server is not present, or the chassis is not powered on.
•
Ready - iDRAC is ready and operating normally.
•
Corrupted - iDRAC firmware is corrupted. Use the iDRAC
firmware update utility to repair the firmware.
• Failed - Unable to communicate with iDRAC. Use the Virtual
Reseat check box to clear the error. If this fails, manually remove
and replace the server to clear the error.
•
FW Update - iDRAC firmware update in progress; allow the
update to complete before attempting any action.
• Initializing - iDRAC reset in progress; wait for the controller to
complete powering-on before attempting any action.
Table 11-13. Virtual Reseat Server
Attribute Description