User's Manual

158 Using the CMC Web Interface
NOTE: When there is a LAN or LAN over IPMI difference, the user is prompted to
accept the QuickDeploy IP address setting. If the difference is the DHCP setting, the
user is prompted to accept the DHCP QuickDeploy setting.
To copy the QuickDeploy settings into the iDRAC Network Settings section,
press the Auto-Populate iDRAC Network Settings button. The QuickDeploy
network configurations settings are copied into the corresponding fields in
the iDRAC Network Configuration Settings table.
NOTE: Changes made to QuickDeploy fields are immediate, but changes made to
one or more iDRAC server network configuration settings may require a couple of
minutes to propagate from the CMC to an iDRAC. Pressing the Refresh button too
soon may display only partially correct data for a one or more iDRAC servers.
iDRAC Network Settings
The iDRAC Network Settings section of the Deploy iDRAC page contains a
table listing all installed server’s iDRAC network configuration settings.
Using this table the user can configure the iDRAC network configurations
settings for each installed server. The initial values displayed for each of the
fields are the current values read from the iDRAC. Changing a field and
clicking Apply iDRAC Network Settings saves the changed field to the
iDRAC server. Follow these steps to enable and set the iDRAC Network
Settings:
1
Log in to the CMC Web interface.
2 Select Servers in the system tree.
3 Click the Setup tab. The Deploy iDRAC page appears.
4 Select the check box for QuickDeploy Enabled to enable the
QuickDeploy settings.