User's Manual

ManualsBrandsDell ManualsSoftwareDell Chassis Management Controller Version 2.0

151

152

153

154

155

156

157

158

159

160

Using the CMC Web Interface 157

To save the selections click the

Save QuickDeploy Settings

button. If you

made changes to the iDRAC network setting, click the

Apply iDRAC

Network Settings

button to deploy the settings to the iDRAC.

To update the table to the last saved QuickDeploy settings, and restore the

iDRAC Network settings to the current values for each installed server,

click the

Refresh

button.

NOTE: Clicking the Refresh button deletes all iDRAC QuickDeploy and iDRAC

Network configuration settings that have not been saved.

The QuickDeploy feature only executes when it is enabled, and a server is

inserted in the chassis. If Set iDRAC Root Password on Server Insertion and

QuickDeploy Enabled are checked, the user is prompted using the LCD

interface to allow or not allow the password change. If there are network

configuration settings that differ from the current iDRAC settings, the user is

prompted to either accept or not accept the changes.

Starting iDRAC IP

Address (Slot 1)

Specifies the static IP address of the iDRAC of the server in

slot 1 of the enclosure. The IP address of each subsequent

iDRAC is incremented by 1 for each slot from slot 1's static

IP address. In the case where the IP address plus the slot

number is greater than the subnet mask, an error message is

displayed.

NOTE: The subnet mask and the gateway are not

incremented like the IP address.

For example, if the starting IP address is 192.168.0.250 and

the subnet mask is 255.255.0.0 then the QuickDeploy IP

address for slot 15 is 192.168.0.265. If the subnet mask were

255.255.255.0, the QuickDeploy IP address range

is not fully within QuickDeploy Subnet

error message is displayed when either the Save

QuickDeploy Settings or Auto-Populate iDRAC Network

Settings buttons are pressed.

iDRAC Netmask Specifies the QuickDeploy subnet mask that is assigned to

all newly inserted servers.

iDRAC Gateway Specifies the QuickDeploy default gateway that is assigned

to all iDRAC present in the chassis.

Table 5-26. QuickDeploy Settings (continued)

Setting Description