User's Manual

Using the CMC Web Interface 151
• Do not use the Refresh button or navigate to another page during the
file transfer.
• To cancel the process, click
Cancel File Transfer and Update - this
option is available only during file transfer.
• Update status displays in the
Update State field; this field is
automatically updated during the file transfer process.
NOTE: The update may take up to one minute for the iKVM.
NOTE: Firmware updates can only be canceled using the GUI; the command line
interface can not cancel a firmware update initiated by the GUI.
When the update is complete, iKVM resets and the new firmware is updated
and displayed on the Updatable Components page.
Updating the IOM Infrastructure Device Firmware
By performing this update, the firmware for a component of the IOM device
is updated, but not the firmware of the IOM device itself; the component is
the interface circuitry between the IOM device and the CMC. The update
image for the component resides in the CMC file system, and the component
displays as an updatable device on the CMC Web GUI only if the current
revision on the component and the component image on the CMC do not
match.
1
Log back in to the CMC Web interface.
2 Select Chassis in the system tree.
3 Click the Update tab. The Updatable Components page appears.
4 Select the IOM device to update by selecting the Update Targets check
box for that IOM device.
5 Click the Apply IOM Update button below the IOM component list.
6 In the Firmware Image field, enter the path to the firmware image file on
your management station or shared network, or click
Browse to navigate to
the file location.
NOTE: The Firmware Image field does not display for an IOM infrastructure device
(IOMINKF) target because the required image resides on the CMC. The CMC
firmware should be updated first, before updating IOMINF firmware.