Quick Reference Guide
RACADM Subcommands 81
Examples
• racadm setniccfg -m server-1 143.166.152.39
143.166.152.1 255.255.255.0
OK
• racadm setniccfg -m server-9 143.166.152.39
143.166.152.1 255.255.255.0
ERROR: Server in slot 9 is an extension of the
server in slot 1.
• racadm setniccfg -k 100 full
Table 2-33. setniccfg Subcommand Options
Option Description
-m <module> Specifies the module for which you want to set the IP
configuration.
<module> can be any of the following:
•
server-
n
where
n=
1–16
•
switch-
n
where
n=
1–6
• chassis
If the -m option is excluded, the module defaults to
chassis.
-d
Enables DHCP for the Ethernet management port (default is
DHCP enabled).
-s
Enables static IP settings by specifying the IP address, subnet
mask, and gateway. <ipAddress>, <netmask>, and
<gateway> must be typed as dot-separated strings.
If this option is not supplied, the existing static settings are
used.
-o
Disables the Ethernet management port completely.
-k
Specifies the speed and duplex for the NIC.
• Speed:
10
,
100
•Duplex:
half
,
full
• (no value supplied): Autonegotiate