Owner's Manual

file:///T|/htdocs/SOFTWARE/smdrac3/cmc/cmc2.0/en/readme/CMC2_0_README_FINAL.TXT[10/26/2012 2:27:28 PM]
* While performing multiple iDRAC firmware updates, the CMC will be
performing CPU-intense activities and may not respond, or respond
slower, for the first couple of minutes. Refrain from running
additional commands during this period. (281719)
* During an iDRAC Firmware update initiated from the CMC that contains
a wrong IP address, file name, or other typo, the result will be
a valid failure. However, the log information will display the
following:
Failed to update iDRAC firmware on blade 5138: Transfer Failed.
Error=0x2.
The log entry has the chassis server and error code numbers
interchanged. (279469)
* During an iDRAC Firmware update initiated from the CMC that contains
a wrong file path that was unintentionally set, then error
code 0x1407, for a file not found, may be displayed. (283351)
* Use the Web-based interface when setting the serial port timeout
to a value greater than 1920 seconds. Use the RACADM command line utility
to set timeout values that are either less than 1920 seconds, or to
disable the timeout by setting a 0 value. (287918)
#####################################################################
KNOWN ISSUES FOR USER INTERFACE ONLINE HELP
#####################################################################
No known issues for this release.
#####################################################################
KNOWN ISSUES FOR DOCUMENTATION
#####################################################################
No known issues for this release.
#####################################################################
FLEXADDRESS (Provided in CMC 1.10 Release)
#####################################################################
Required Module Firmware to use Chassis FlexAddress feature:
----------------------------------------------------------------
Component | Minimum required version
----------------------------------------------------------------
Ethernet Mezzanine card - | Firmware 4.4.1,
Broadcom M5708t/M5708is,M5708 | iSCSI boot firmware 2.7.11,
| PXE firmware 4.4.3
----------------------------------------------------------------
FC Mezzanine card - | BIOS 2.04 or later
QLogic QME2472
----------------------------------------------------------------
FC Mezzanine card - | BIOS 3.03a3 and firmware 2.72A2
Emulex LPe1105-M4 | or later
----------------------------------------------------------------
Blade Server BIOS | (PE M600) BIOS 2.02 or later