Users Guide

Viewing World Wide Name or Media Access Control IDs
The WWN/MAC Summary page allows you to view the World Wide Name (WWN) conguration and Media Access Control (MAC)
address of a slot in the chassis.
Command messages
The following table lists the RACADM commands and output for common FlexAddress situations.
Table 26. FlexAddress commands and output
Situation Command Output
SD card in the CMC module is bound
to another service tag.
$racadm featurecard -s
The feature card inserted is
valid and contains the
following feature(s)
FlexAddress: bound to another
chassis, svctag = <Service tag
Number> SD card SN = <Valid
flex address serial number>
SD card in the CMC module that is
bound to the same service tag.
$racadm featurecard -s
The feature card inserted is
valid and contains the
following feature(s)
FlexAddress: bound
SD card in the CMC module that is
not bound to any service tag.
$racadm featurecard -s
The feature card inserted is
valid and contains the
following feature(s)
FlexAddress:not bound
FlexAddress feature not on the
chassis for any reason (No SD card
inserted/ corrupt SD card/ after
feature deactivated /SD card bound
to a dierent chassis).
$racadm setflexaddr [-f
<fabricName> <slotState>]
$racadm setflexaddr [-i <slot#>
<slotstate>]
ERROR: Flexaddress feature is
not active on the chassis
Guest user attempts to set
FlexAddress on slots/fabrics.
$racadm setflexaddr [-f
<fabricName> <slotState>]
$racadm setflexaddr [-i <slot#>
<slotstate>]
ERROR: Insufficient user
privileges to perform operation
Deactivating FlexAddress feature with
chassis powered ON.
$racadm feature -d -c
flexaddress
ERROR: Unable to deactivate the
feature because the chassis is
powered ON
Guest user tries to deactivate the
feature on the chassis.
$racadm feature -d -c
flexaddress
ERROR: Insufficient user
privileges to perform operation
Changing the slot/fabric FlexAddress
settings while the server modules are
powered ON.
$racadm setflexaddr -i 1 1
ERROR: Unable to perform the
set operation because it
affects a powered ON server
Changing the Flexaddress settings of
slot or fabric, when the CMC
Enterprise License is not installed.
$racadm setflexaddr -i<slotnum>
<status>
$racadm setflexaddr -
f<FabricName> <status>
ERROR: SWC0242 : A required
license is missing or expired.
Obtain an appropriate license
and try again, or contact your
service provider for additional
details.
NOTE: To resolve this issue, you must
have a FlexAddress Enablement
license.
119