Release Notes

• The cfgRacTuneIdracDNSLaunchEnable object and the "iDRAC Launch Method" setting on the
Chassis Overview > Setup > General CMC Graphical Interface requires the Chassis Configuration
Administrator privilege.
• Microsoft Windows Server 2012, Windows Server 2008 R2, Windows 7 do not support TLS 1.2 and
TLS 1.1. Install update below to enable TLS 1.2 and TLS 1.1 as a default secure protocols in
WinHTTP in Windows. For details, see the Microsoft knowledge base article 3140245 at
support.microsoft.com .
• Supports LDAP authentication with OPEN-DS. OPEN-DS must have DH key larger than 768 bits.
Known Issues
Issue 1:
Description
PCIe card device name displayed in iDRAC GUI and CMC GUI are not same for Broadcom/Qlogic 10G
card.
Resolution
Refer to the iDRAC GUI, it is accurate and current.
Versions/Systems Affected
CMC for PowerEdge FX2s 1.1 or later
Issue 2:
Description
An error occurs while importing CMC configuration file using local racadm or remote racadm.
Resolution
This issue occurs when IPv6 is enabled or disabled from the configuration file. Enable or disable IPv6
using the command “racadm config -g cfgIPv6LanNetworking -o cfgIPv6Enable 0”.
Versions/Systems Affected
CMC for PowerEdge FX2 1.1 or later
Limitations
Issue 1:
Description
In the Microsoft Edge browser, the Boot Identity Profiles page in the CMC GUI is slow when 1500 or
more MAC addresses are created from the MAC pool for the Boot Identity profile.
Resolution
Create less than 1500 MAC address in the Microsoft Edge browser. Use other supported browsers for
more than 1500 MAC addresses.
Versions/Systems Affected
CMC for PowerEdge FX2 1.40 or later
Issue 2:
Description
Racresetcfg does not work when the six RSA-4096 or four RSA-2048, and two 2048 DSA SSH public keys
are uploaded to the CMC.
Resolution