Reference Guide

The sslcsrgen -s subcommand returns one of the following status codes:
• CSR was generated successfully.
• CSR does not exist.
Example
racadm sslcsrgen -s
or
racadm sslcsrgen -g -f c:\csr\csrtest.txt
NOTE: Before a CSR can be generated, the CSR elds must be congured in the RACADM cfgRacSecurity group. For
example:
racadm config -g cfgRacSecurity -o cfgRacSecCsrCommonName MyCompany
NOTE: In telnet/ssh console, you can only generate and not download the CSR le.
NOTE: The duration for generating a CSR key depends on the length specied for the key.
sslresetcfg
Description Restores the web-server certicate to factory default and restarts web-server. The certicate
takes eect 30 seconds after the command is entered.
To use this subcommand, you must have the Chassis Conguration Administrator privilege for
CMC.
Synopsis
racadm sslresetcfg
Example
$ racadm sslresetcfg
Certificate generated successfully and webserver restarted.
testemail
Description
Sends a test e-mail from CMC to a specied destination. Prior to executing the test e-mail
command, make sure that the SMTP server is congured and the specied index in the
RACADM cfgEmailAlert group is enabled and congured properly.
Synopsis
racadm testemail -i <index>
Input -i — Species the index of the e-mail alert to test.
Output
Success: Test e-mail sent successfully
Failure: Unable to send test e-mail
Example Commands for the cfgEmailAlert group:
• Enable the alert —
racadm config -g cfgEmailAlert -o cfgEmailAlertEnable -i 1
• Set the destination e-mail address —
racadm config -g cfgEmailAlert -o cfgEmailAlertAddress -i 1
[e-mail]
• Set the custom message that is sent to the destination e-mail address —
racadm config -g cfgEmailAlert -o cfgEmailAlertCustomMsg -i 1
"This is a test!"
• Make sure that the SMTP IP address is congured properly —
racadm config -g cfgRemoteHosts -o cfgRhostsSmtpServerIpAddr
192.168.0.152
84