Connectivity Guide

iDRAC MIB

The Integrated Dell Remote Access Controller (iDRAC) MIB (lename iDRAC-SMIv1.mib/ iDRAC-SMIv2.mib) is the MIB supported

by the Integrated Dell Remote Access Controller 7 and 8 (iDRAC7 and iDRAC8). This MIB provides management data that allows you

to monitor devices and software on a system via an out-of-band connection to the iDRAC7 and iDRAC8 of a system.

NOTE: From iDRAC7 rmware release r1.30.30 or later and iDRAC8, the iDRAC7 or iDRAC8 MIB le is published in both

types of SMI (Structure of Managed Information) notations: SMIv1 and SMIv2. The SMIv1 copy of the iDRAC7 or

iDRAC8 MIB le is named iDRAC-SMIv1.mib. And the SMIv2 copy is named iDRAC-SMIv2.mib. Prior to iDRAC7 rmware

release r1.30.30, only a SMIv1 copy was published. And the le name of the SMIv1 copy was

iDRAC-MIB.txt.

Supported Systems

The iDRAC MIB supported on the following systems for this release:

Blade Servers

The Blade servers for this release:

• PowerEdge M830

• PowerEdge FC430

Rack and Tower Servers

The Rack and Tower servers for this release:

• PowerEdge R930

• PowerEdge R530xd

• C6320

• PowerEdge FX2/FX2s 1.2

• PowerEdge FD332

• DSS 2500

• DSS 1500

iDRAC Supported SNMP Versions

The following table identies the SNMP versions that support iDRAC for the given SNMP operations.

Table 166. iDRAC Supported SNMP Versions

SNMP Operations Supported SNMP version

GET, GETNEXT, GETBULK SNMP v1, v2c and v3

TRAP SNMP v1, SNMP v2c and SNMP v3

NOTE: iDRAC does not support the SNMP SET operation for any data.