User's Manual

For example:

• To remove a server VLAN, disable the VLAN capabilities of the specified server's network:

racadm setniccfg -m server-<n> -v

The valid values for <n> are 1–4.

For example:

racadm setniccfg -m server-1 -v

Configuring iDRAC Virtual LAN Tag Settings Using Web Interface

To configure Vitual LAN(VLAN) for server:

1. Go to any of the following pages:

• In the left pane, click Chassis Overview → Network → VLAN.

• In the left pane, click Chassis Overview → Server Overview and click Setup → VLAN.

2. On the VLAN Tag Settings page, in the iDRAC section, enable VLAN for the server(s), set the priority

and enter the ID. For more information about the fields, see the Online Help.

3. Click Apply to save the settings.

Setting First Boot Device

You can specify the CMC first boot device for each server. This may not be the actual first boot device for

the server, or may not even represent a device present in that server. It represents a device sent by CMC

to the server and used as its first boot device of that server. This device can be set as the default first-boot

device or an one-time device so that you can boot an image to perform tasks such as running

diagnostics or reinstalling an operating system.

You can set the first boot device for the next boot only or for all subsequent reboots. You can also set the

first boot device for the server. The system boots from the selected device on the next and subsequent

reboots and remains as the first boot device in the BIOS boot order, until it is changed again either from

the CMC web interface (Chassis Overview → Server Overview → Setup → First Boot Device) or from the

BIOS boot sequence.

NOTE: The first boot device setting in CMC web Interface overrides the system BIOS boot settings.

The boot device that you specify must exist and contain a bootable media.

You can set the following devices for first boot.

Table 8. Boot Devices

Boot Device Description

PXE Boot from a Preboot Execution Environment (PXE) protocol on the Network Interface

Card.

Hard Drive Boot from the hard disk drive on the server.

Local

CD/DVD

Boot from a CD or DVD drive on the server.