User's Manual

– cfgEmailAlert — cfgEmailAlertAddress

– cfgTraps — cfgTrapsAlertDestIPAddr

– cfgStandardSchema — cfgSSADRoleGroupName

– cfgServerInfo — cfgServerBmcMacAddress

Modifying the CMC IP Address

When you modify the CMC IP address in the configuration file, remove all unnecessary <variable> =

<value> entries. Only the actual variable group’s label with [ and ] remains, including the two

<variable> = <value> entries pertaining to the IP address change.

Example:

# Object Group "cfgLanNetworking"

[cfgLanNetworking]

cfgNicIpAddress=10.35.10.110

cfgNicGateway=10.35.10.1

This file is updated as follows:

# Object Group "cfgLanNetworking"

[cfgLanNetworking]

cfgNicIpAddress=10.35.9.143

# comment, the rest of this line is ignored

cfgNicGateway=10.35.9.1

The command racadm config -f <myfile>.cfg parses the file and identifies any errors by line

number. A correct file updates the proper entries. Additionally, you can use the same getconfig

command from the previous example to confirm the update.

Use this file to download company-wide changes or to configure new systems over the network with the

command, racadm getconfig -f <myfile>.cfg.

NOTE: Anchor is a reserved word and should not be used in the .cfg file.

Viewing and Ending CMC Sessions

You can view the number of users currently logged in to iDRAC7 and end the user sessions.

NOTE: To end a session, you must have Chassis Configuration Administrator privilege.

Viewing and Ending CMC Sessions Using Web Interface

To view or end a session using the web interface:

1. In the left pane, go to Chassis Overview and click Network → Sessions.

The Sessions page displays the session ID, username, IP address, and session type. For more

information about these properties, see the Online Help.

2. To end the session, click Terminate for a session.