Quick Reference Guide

• racadm setflexaddr -f A 1

Fabric A FlexAddress state set successfully

• racadm setflexaddr -f idrac 1

setled

Description Sets the state (blinking or not blinking) of the LED on the specified module.

To blink or unblink the chassis, I/O modules or the CMC, you must have the Debug Administrator

privilege on CMC. To enable the servers to blink or unblink, you must have the Server

Administrator or Debug Administrator privilege on CMC.

Synopsis

racadm setled -m <module> -l <ledState>

Input

• -m <

module

> - Specifies the module whose LED you want to configure.

module

> can be one of the following:

— server-n, where

=1–4

— switch-n, where n=1

— cmc-active

— chassis

• -l <

ledstate

> - Specifies whether the LED should blink.

ledstate

> can be one of the following:

– 0 — no blinking

– 1 — blinking

Example

• racadm setled -m server-1 -1 1

LED state was set successfully.

NOTE: The setled command generates an error when used on the extension slot of a

multi-slot server.

• racadm setled -m server-9 -1 1

ERROR: Server in slot 9 is an extension of the server in slot 1.

setniccfg

Description Sets the iDRAC IP address. It displays an error message if the requested operation

could not be performed, or a success message, if the operation is completed

successfully.

To use this subcommand, you must have the Configure iDRAC privilege.

NOTE: The terms NIC and Ethernet management port may be used

interchangeably.

Synopsis

• racadm setniccfg -d

• racadm setniccfg -d6

• racadm setniccfg -s <IPv4Address> <netmask> <IPv4

gateway>