Users Guide

3. Click Save QuickDeploy Settings to save the settings. If you have made changes to the iDRAC

network setting, click Apply iDRAC Network Settings to deploy the settings to the iDRAC.

The QuickDeploy feature only executes when it is enabled, and a server is inserted in the chassis. If

Set iDRAC Root Password on Server Insertion and QuickDeploy Enabled are enabled, the user is

prompted using the LCD interface to allow or not allow the password change. If there are network

configuration settings that differ from the current iDRAC settings, the user is prompted to either

accept or reject the changes.

NOTE: If there is a LAN or IPMI over LAN difference, the user is prompted to accept the

QuickDeploy IP address setting. If the difference is the DHCP setting, the user is prompted to

accept the DHCP QuickDeploy setting.

To copy the QuickDeploy settings into the iDRAC Network Settings section, click Auto-Populate

Using QuickDeploy Settings. The QuickDeploy network configurations settings are copied into the

corresponding fields in the iDRAC Network Configuration Settings table.

NOTE: Changes made to QuickDeploy fields are immediate, but changes made to one or more

iDRAC server network configuration settings may require a couple of minutes to propagate

from CMC to iDRAC. Clicking Refresh early may display only partially correct data for one or

more iDRAC servers.

Modifying iDRAC Network Settings for Individual Server iDRAC

Using this feature, you can configure the iDRAC network configurations settings for each installed server.

The initial values displayed for each of the fields are the current values read from the iDRAC. To use this

feature, you must have an Enterprise License.

To modify the iDRAC Network Settings:

1. In the left pane, click Server Overview, and then click Setup. On the Deploy iDRAC page the iDRAC

Network Settings section lists the iDRAC IPv4 and IPv6 network configuration settings of all the

installed servers.

2. Modify the iDRAC network settings as required for the server(s).

NOTE: You must select the Enable LAN option to specify the IPv4 or IPv6 settings. For

information about the fields, see the Online Help.

3. To deploy the setting to iDRAC, click Apply iDRAC Network Settings. Any changes made to the

QuickDeploy Settings are also saved.

The iDRAC Network Settings table reflects future network configuration settings; the values shown

for installed servers may or may not be the same as the currently installed iDRAC network

configuration settings. Click Refresh to update the iDRAC Deploy page with each installed iDRAC

network configuration settings after changes are made.

NOTE: Changes made to QuickDeploy fields are immediate, but changes made to one or more

iDRAC server network configuration settings may require a couple of minutes to propagate

from CMC to iDRAC. Clicking Refresh too soon may display only partially correct data for a one

or more iDRAC servers.

Modifying iDRAC Network Settings Using RACADM

RACADM config or getconfig commands support the -m <module> option for the following

configuration groups:

• cfgLanNetworking