Users Guide

The QuickDeploy feature only executes when it is enabled, and a server is inserted in the chassis.

To copy the QuickDeploy settings into the iDRAC Network Settings section, click Auto-Populate

Using QuickDeploy Settings. The QuickDeploy network configurations settings are copied into the

corresponding fields in the iDRAC Network Configuration Settings table.

NOTE: Changes made to QuickDeploy fields are immediate, but changes made to one or more

iDRAC server network configuration settings may require a couple of minutes to propagate

from CMC to iDRAC. Clicking Refresh early may display only partially correct data for one or

more iDRAC servers.

QuickDeploy IP address assignments for servers

The following tables show the way that the QuickDeploy IP addresses assigned to the servers based on

the sleds present in the FX2/FX2s Chassis:

• Two full-width sleds in the chassis:

• Four half-width sleds in the chassis:

• Eight quarter-width sleds in the chassis:

NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.

• Four FM120x4 sleds in the chassis:

NOTE: The Reserved QuickDeploy IPAddresses must be set to 16.

• Top row contains only quarter-width sleds and bottom row contains only half-width sleds:

NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.

• Top row contains only full-width sleds and bottom row contains only half-width sleds: