Users Guide

Setting Description

network. Quick Deploy feature does not work

for servers that are inserted into slots for which

there is no reserved static IPv4 address.

Starting iDRAC IPv4 Address (Slot 1) Specifies the static IP address of iDRAC in the

server, in slot 1 of the enclosure. The IP address

of each subsequent iDRAC is incremented by 1

for each slot from slot 1's static IP address. In the

case where the IP address plus the slot number

is greater than the subnet mask, an error

message is displayed.

NOTE: The subnet mask and the gateway

are not incremented such as the IP address.

For example, if the starting IP address is

192.168.0.250 and the subnet mask is

255.255.0.0 then the QuickDeploy IP address

for slot 4c is

192.168.0.265. If the subnet

mask is 255.255.255.0, the QuickDeploy IP

address range is not fully within

QuickDeploy Subnet

error message is

displayed when you click Save QuickDeploy

Settings or Auto-Populate Using QuickDeploy

Settings.

iDRAC IPv4 Netmask Specifies the QuickDeploy subnet mask that is

assigned to all newly inserted servers.

iDRAC IPv4 Gateway Specifies the QuickDeploy default gateway that

is assigned to all the DRAC present in the

chassis.

Enable iDRAC IPv6 Enables IPv6 addressing for each iDRAC present

in the chassis that is IPv6 capable.

Enable iDRAC IPv6 Autoconfiguration Enables the iDRAC to obtain IPv6 settings

(address and prefix length) from a DHCPv6

server and also enables stateless address auto

configuration. By default, this option is enabled.

iDRAC IPv6 Gateway Specifies the default IPv6 gateway to be assigned

to the iDRACs. The default value is "::".

iDRAC IPv6 Prefix Length Specifies the prefix length to be assigned for the

IPv6 addresses on the iDRAC. The default value

is 64.

Use CMC DNS Settings Enables the CMC DNS Server settings ( IPv4 and

IPv6) that are propagated to iDRAC when a blade

server is inserted in the chassis.

3. Click Save QuickDeploy Settings to save the settings. If you have made changes to the iDRAC

network setting, click

Apply iDRAC Network Settings to deploy the settings to the iDRAC.