Users Guide

Viewing currently installed firmware versions

You can view the currently installed firmware versions using the CMC web interface or RACADM.

Viewing currently installed firmware versions using CMC web interface

In the CMC web interface, go to any of the following pages to view the current firmware versions:

• Chassis Overview → Update

• Chassis Overview → Chassis Controller → Update

• Chassis Overview → Server Overview → Server Component Update

The Firmware Update page displays the current version of the firmware for each listed component and

allows you to update the firmware to the latest version.

If the chassis contains an earlier generation server, whose iDRAC is in recovery mode or if CMC detects

that iDRAC has corrupted firmware, then the earlier generation iDRAC is also listed on the Firmware

Update page.

Viewing currently installed firmware versions using RACADM

You can view the currently installed firmware versions using racadm getversion command. For more

information about other RACADM commands, see the

Dell Chassis Management Controller for

PowerEdge FX2/FX2s RACADM Command Line Reference Guide.

Updating the CMC firmware

You can update the CMC firmware using web interface or RACADM. The firmware update, by default,

retains the current CMC settings.

NOTE: To update firmware on CMC, you must have the Chassis Configuration Administrator

privilege.

NOTE: You cannot update the CMC firmware if the firmware image file does not contain a

verification signature or it contains a verification signature, which is not valid or corrupted.

NOTE: You cannot downgrade the CMC firmware to an earlier version if the computed signature of

that earlier version is not recognized by the current CMC firmware.

If a Web user interface session is used to update system component firmware, the Idle Timeout (0, 60–

10800) setting must be set to a higher value to accommodate the file transfer time. In some cases, the

firmware file transfer time may be as high as 30 minutes. To set the idle timeout value, see Configuring

Services.

During CMC firmware updates, it is normal for some or all of the fan units in the chassis to rotate at 100%

speed.

To avoid disconnecting other users during a reset, notify authorized users who may log in to CMC and

check for active sessions on the Sessions page. To open the Sessions page, click Chassis Overview in the

left pane, click Network, and then click the Sessions.