Users Guide

4. On the Front Panel Configuration page, under the KVM Configuration section, for KVM Mapped

option, select the desired server from the drop down list.

5. Click Apply.

To map a Server to KVM using racadm, useracadm config -g cfgKVMInfo -o cfgKvmMapping

[server slot #] command.

To view the current KVM mapping using racadm, use racadm getconfig -g cfgKVMInfo.

Configuring chassis management at server mode

This feature allows you to manage and monitor the chassis shared components and chassis nodes as

rack servers. When this feature is enabled, you can use the iDRAC RACADM proxy, blade server operating

systems and Lifecycle Controller to do the following:

• Monitor and manage chassis fans, power supplies, temperature sensors

• Update and configure the CMC firmware

Configuring chassis management at server using CMC web interface

To enable chassis management at server mode:

1. In the left pane, click Chassis Overview → Setup → General.

2. In the General Chassis Settings page, from the Chassis Management at Server Mode drop-down,

select one of the following modes:

• None — This mode does not enable you to monitor or manage the chassis component through

iDRAC, OS, or Lifecycle Controller.

• Monitor — This mode enables you to monitor the chassis components but you cannot perform

any firmware update through iDRAC, OS, iDRAC RACADM proxy, or Lifecycle Controller.

• Manage and Monitor — This mode enables you to monitor the chassis components and update

the CMC firmware using DUP through iDRAC, OS, iDRAC RACADM, or Lifecycle Controller.

Configuring chassis management at server mode using RACADM

To enable the Chassis Management at server using RACADM, use the following commands:

• To disable Chassis Management at Server mode, use:

racadm config –g cfgRacTuning – cfgRacTuneChassisMgmtAtServer 0

• To change Chassis Management at Server mode to monitor, use:

racadm config –g cfgRacTuning – cfgRacTuneChassisMgmtAtServer 1

• To change Chassis Management at server mode to manage and monitor, use:

racadm config –g cfgRacTuning – cfgRacTuneChassisMgmtAtServer 2