Release Notes

• When Certificate Validation is “Enabled”, FQDN of the system should be provided. If the IP address
of the Domain Controller is specified when the certificate validation is enabled, the Active
Directory login may not work.
• The cfgRacTuneIdracDNSLaunchEnable object and the "iDRAC Launch Method" setting on the
Chassis Overview > Setup > General CMC Graphical Interface requires the Chassis Configuration
Administrator privilege.
Known Issues
Issue 1 (180253):
Description
PCIe card device name displayed in iDRAC GUI and CMC GUI are not same for Broadcom/Qlogic 10G
card.
Resolution
Refer to the iDRAC GUI, it is accurate and current.
Versions/Systems Affected
None
Issue 2 (234547):
Description
An error occurs while importing CMC configuration file using local racadm or remote racadm.
Resolution
This issue occurs when IPv6 is enabled or disabled from the configuration file. Enable or disable IPv6
using the command “racadm config -g cfgIPv6LanNetworking -o cfgIPv6Enable 0”.
Versions/Systems Affected
CMC PowerEdge FX2 1.1 or later
Limitations
Issue 1 (191858):
Description
The Server Profile page hangs after applying a profile to multiple servers.
Resolution
Do not perform any operations in GUI until the pop-up message is displayed in the GUI.
Versions/Systems Affected
All versions including CMC PowerEdge FX2 1.3
Installation
Prerequisites
See the Dell Chassis Management Controller for PowerEdge FX2 Version 1.30 User's Guide for the
following information:
• Prerequisites
• Hardware and software requirements