Reference Guide

• racadm setniccfg [-i <slot>] —v [<vlan_id> <vlan_priority>]

Input

• -d — Enables DHCP for the NIC (default is “DHCP disabled”.)

• -d6 — Enables AutoCong for the NIC. It is enabled by default.

• -s — Enables static IP settings. The IPv4 address, netmask, and gateway can be specied.

Otherwise, the existing static settings are used. < IPv4Address >, < netmask >, and <

gateway > must be typed as dot-separated strings.

racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.0.1

• -s6 — Enables static IPv6 settings. The IPv6 address, Prex Length, and the IPv6 gateway

can be specied.

• -o — Enable or disable NIC.

• -m<module> — Must be one of the following values:

– chassis: Default state if - m is not specied.

– server-n: where n=1–4

– server-nx: where n=1–4; x=a-d (lower case)

– switch-n: where n=1–2

• -i <slot> — Must be number n, where n=1 to 4

• -v — When performing on a switch, release and renew any DHCP lease on that port for the

changes to be eective. The VLAN settings must be one of the following legal values:

– no arguments imply remove vlan tag, not compatible with server-nx. For example

(“server-4b”) notation

– <vlan_id> 1 to 4000, 4021, and 4094 inclusive

– vlan_priority> 0 to 7, inclusive

• -p — Disables IPV4 (default)/IPV6 protocol

• -k — Must be one of the following legal values:

– no arguments implies autonegotiate

– <speed> = 10, 100

– <duplex> = half, full

• -r — Enable or disable redundant mode. The legal values are:

– 1 — Enable

– 0 — Disable

NOTE: The options -o, -k, -p, and -r can be specied for chassis only.

• -6:

– Sets static IPv6 addresses (w/ -s option)

– Enables autocong for IPv6 (w/ -d option)

– Disables IPv6 (w/ -p option)

– Can be specied for chassis or servers

Example

• racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.0.1

• racadm setniccfg -d

• racadm setniccfg -d6

• Conguration of speed = 100Mbps and duplex= full duplex:

racadm setniccfg -k 100 full

• Conguration of speed and duplex to autonegotiate:

racadm setniccfig -k

• Conguration of redundant mode:

racadm setniccfg -r 1