Reference Guide

• -l - Displays the rmware versions Lifecycle Controller components.
• -f < lter > - Filters the components. Must be used with -1 and be one of the following
values:
– bios: BIOS
– idrac: iDRAC
– usc: Unied Server Congurator (Lifecycle Controller)
– diag: 32-bit Diagnostics
– drivers: OS Driver Package
– nic-x: Network Interface card. See -l output for possible values of x.
• -m < module > - Species the module or device for which you must retrieve the version
information.
< module > is one of the following:
– server-n , where n = 1 to 4.
– switch-n , where n = 1 to 2.
– CMC
– mainboard
Example
• Retrieve the version for a server 4
racadm getversion -m server-4
• Retrieve the Lifecycle Controller component versions for servers 1 and 3:
racadm getversion -l -m server-1 -m server-3
• Retrieve the Lifecycle Controller BIOS versions for servers 1 and 3:
racadm getversion -l -m server-1 -m server-3 -f bios
• Retrieve the version for all modules:
racadm getversion
• Retrieve the iDRAC version in all the servers that are attached to the chassis:
racadm getversion -f idrac
ifcong
Description
Displays the contents of the network interface table.
To use this subcommand, you must have the Administrator privilege.
Synopsis
racadm ifconfig
Example
$ racadm ifconfig
eth0 Link encap:Ethernet HWaddr 00:1D:09:FF:DA:23
inet addr:192.168.0.1 Bcast:192.168.0.120
Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500
Metric:1
RX packets:2550665 errors:0 dropped:0 overruns:0
frame:0
TX packets:0 errors:0 dropped:0 overruns:0
carrier:0
collisions:0 txqueuelen:1000
RX bytes:272532097 (259.9 MiB) TX bytes:0
(0.0 B)
59