Reference Guide
1
Introduction
This document provides information about the RACADM subcommands, supported RACADM interfaces, and property database
groups and object denitions of CMC for PowerEdge FX2/FX2s.
NOTE: The terms “storage sled” and “storage module” are used interchangeably in this document.
What’s new in this release
This release supports:
• The -s option in the getioinfo command.
• The -h option in the getslotname and setslotname commands.
• The following options in the get command.
– -u
– -p
– -l
– -t
– --clone
– --replace
– --includeph
• The following options in the set command.
– -f
– -u
– -p
– -l
– -t
• The cfgSerialConsoleQuitKey (Read or Write) object added to the cfgSerial group.
• The new column <Mode> added in the output for the getioinfo command.
Supported RACADM Interfaces
The RACADM command-line utility provides a scriptable interface that allows you to remotely congure your Chassis Management
Controller (CMC). The utility runs on the management station and the managed system. It is available on the Dell OpenManage
Systems Management and Documentation DVD or at support.dell.com.
The RACADM utility supports the following interfaces:
• SSH or Telnet — Also referred as Firmware RACADM, is accessible by logging in to CMC using SSH or telnet. You do not have to
specify the CMC IP, user name or password to run Firmware RACADM commands.
• Remote — Supports executing RACADM commands from a remote management station such as a laptop or desktop. You must
install the DRAC Tools utility from the OpenManage software on the remote computer to run Remote RACADM commands. To
execute Remote RACADM commands, you must formulate the command such as a an SSH/Telnet RACADM command except
11