Users Guide

Enabling or Disabling Default Password Warning Message Using Web Interface
To enable or disable the display of the default password warning message after logging in to iDRAC:
1. Go to Chassis Controller User Authentication Local Users .
The Users page is displayed.
2. In the Default Password Warning section, select Enable, and then click Apply to enable the display of the Default
Password Warning page when you log in to CMC. Else, select Disable.
Alternatively, if this feature is enabled and you do not want to display the warning message for subsequent login
operations, on the Default Password Warning page, select the Do not show this warning again option, and then
click Apply.
Enabling or Disabling Warning Message to Change Default Login Password Using
RACADM
To enable the display of the warning message to change the default login password using RACADM, use racadm
config -g cfgRacTuning -o cfgRacTuneDefCredentialWarningEnable<0> or <1> object. For
more information, see the
Chassis Management Controller for PowerEdge VRTX RACADM Command Line Reference
Guide
available at dell.com/support/manuals.
Updating I/O Module Infrastructure Device Firmware
By performing this update, the firmware for a component of the I/O Module device is updated, but not the firmware of
the I/O Module device itself; the component is the interface circuitry between the I/O Module device and CMC. The
update image for the component resides in the CMC file system, and the component displays as an updatable device on
the CMC web interface only if the current revision on the component and the component image on CMC do not match.
Before updating I/O Module infrastructure device firmware, make sure the CMC firmware is updated.
NOTE:
CMC allows I/O Module infrastructure device firmware (IOMINF) updates only if it detects that the IOMINF firmware is
out-of-date with the image contained in CMC file system. If the IOMINF firmware is up-to-date, CMC prevents IOMINF
updates. Up-to-date IOMINF devices are not listed as updatable devices.
48