Users Guide

Command Messages
The following table lists the RACADM commands and output for common FlexAddress situations.
Table 26. FlexAddress Commands and Output
Situation Command Output
SD card in the active CMC module is
bound to another service tag.
$racadm featurecard -s
The feature card inserted
is valid and contains the
following feature(s)
FlexAddress: bound to
another chassis, svctag =
<Service tag Number> SD
card SN = <Valid flex
address serial number>
SD card in the active CMC module
that is bound to the same service tag.
$racadm featurecard -s
The feature card inserted
is valid and contains the
following feature(s)
FlexAddress: bound
SD card in the active CMC module
that is not bound to any service tag.
$racadm featurecard -s
The feature card inserted
is valid and contains the
following feature(s)
FlexAddress:not bound
FlexAddress feature not active on the
chassis for any reason (No SD card
inserted/ corrupt SD card/ after
feature deactivated /SD card bound to
a different chassis).
$racadm setflexaddr [-f
<fabricName> <slotState>]
$racadm setflexaddr [-i
<slot#> <slotstate>]
ERROR: Flexaddress
feature is not active on
the chassis
Guest user attempts to set
FlexAddress on slots/fabrics.
$racadm setflexaddr [-f
<fabricName> <slotState>]
$racadm setflexaddr [-i
<slot#> <slotstate>]
ERROR: Insufficient user
privileges to perform
operation
Deactivating FlexAddress feature with
chassis powered ON.
$racadm feature -d -c
flexaddress
ERROR: Unable to
deactivate the feature
because the chassis is
powered ON
Guest user tries to deactivate the
feature on the chassis.
$racadm feature -d -c
flexaddress
ERROR: Insufficient user
privileges to perform
operation
Changing the slot/fabric FlexAddress
settings while the server modules are
powered ON.
$racadm setflexaddr -i 1
1
ERROR: Unable to perform
the set operation because
it affects a powered ON
server
Changing the Flexaddress settings of
slot or fabric, when the CMC
Enterprise License is not installed.
$racadm setflexaddr -
i<slotnum> <status>
$racadm setflexaddr -
f<FabricName> <status>
ERROR: SWC0242 : A
required license is
missing or expired.
Obtain an appropriate
license and try again, or
contact your service
provider for additional
details.
NOTE: To resolve this issue, you
must have a FlexAddress
Enablement license.
152