Users Guide

Configuring storage sleds

Half-width storage sleds that are used in the FX2s chassis contain the following:

• One or two RAID controllers

• Maximum of 16 disk drives

You can configure individual storage sleds containing two RAID controllers to operate in the following

modes:

• Split-single

• Split-dual

• Joined

NOTE: Do not insert a storage sled in slot 1 of the chassis as it is not a valid location for storage

sleds.

NOTE: This section is applicable only to dual-controller storage modules.

NOTE: You can also configure and monitor storage sleds using the iDRAC Comprehensive

Embedded Management (CEM). For more information, see the Integrated Dell Remote Access

Controller (iDRAC) User’s Guide.

Configuring storage sleds in split-single mode

In split-single mode, the two RAID controllers are mapped to a single compute sled. Both the controllers

are enabled and each controller is connected to eight disk drives.

Configuring storage sleds in split-dual mode

In split-dual mode, both RAID controllers in a storage sled are connected to two compute sleds.

If a storage sled is located below a full-width PowerEdge FC830 sled, it can be configured in the split-

dual mode. But the controllers are connected to a single compute sled and only that compute sled is

reported.

If a storage sled is configured in the split dual mode and is in a location where it cannot be connected to

two compute sleds, then the second controller is not connected to any compute sled.

You must have the Chassis Configuration Administrator privilege and power off the compute sled before

changing the setting.