Users Guide

Completion status and troubleshooting

To check the completion status of an applied BIOS profile:

1. In the left pane, click Chassis Overview → Server Overview → Setup → Profiles.

2. On the Server Profiles page, note down the Job ID (JID) of the submitted job from the Recent

Profile Log section.

3. In the left pane, click Server Overview → Troubleshooting → Lifecycle Controller Jobs. Search for

the same JID in the Jobs table. For more information about performing Lifecycle Controller jobs

using CMC, see

Lifecycle Controller Job Operations.

Quick Deploy of profiles

The Quick Deploy feature enables you to assign a stored profile to a server slot. Any server supporting

server configuration replication that is inserted into a slot is configured using the profile assigned to that

slot. You can perform the Quick Deploy action only if the Action When Server is Inserted option in the

Deploy iDRAC page is set to Server Profile or Quick Deploy and Server Profile. Selecting this option

allows to apply the server profile assigned when a new server is inserted in the chassis. To go to the

Deploy iDRAC page, select Server Overview → Setup → iDRAC . Profiles that can be deployed are

contained in the SD card.

NOTE: To set up the profiles for quick deploy, you must have Chassis Administrator privileges.

Assigning server profiles to slots

The Server Profiles page enables you to assign server profiles to slots. To assign a profile to the chassis

slots:

1. In the Server Profiles page, click Profiles for QuickDeploy section.

The current profile assignments are displayed for the slots in the select boxes contained in the Assign

Profile column.

NOTE: You can perform the Quick Deploy action only if the Action When Server is Inserted

option in the Deploy iDRAC page is set to Server Profile or Quick Deploy then Server Profile.

Selecting this option allows to apply the server profile assigned when a new server is inserted in

the chassis.

2. From the drop-down menu, select the profile to assign to the required slot. You can select profiles to

apply to multiple slots.

3. Click Assign Profile.

The profiles gets applied to the selected slots.

NOTE: When the FM120x4 sled is inserted, the stored profile assigned to the server slot is applied to

all the four servers.