Users Guide

correspond to a fan speed offset (increase) of 20%, 50%, and 100% of the maximum speed respectively.

There are also minimum speeds setup for each option, which are 35% for Low, 65% for Medium, and

100% for High.

Using the Medium Fan Offset setting for example, increases the speed of fans by 50% of its maximum

speed. The increase is above the speed already set by the system for cooling on the basis of installed

hardware configuration.

With any of the Fan Offset options enabled, the power consumption will be increased. The system will be

louder with the Low offset, noticeably louder with the Medium offset, and significantly louder with the

High offset. When the Fan Offset option is not enabled, the fan speeds will be reduced to the default

speeds required for system cooling for the installed hardware configuration.

To set the offset feature, go to Chassis Overview → Fans → Setup. On the Advanced Fan Configuration

page, from the Value drop-down menu corresponding to Fan Offset, select appropriately.

For more information about the Fan Offset feature, see the Online Help.

For setting up these features by using RACADM commands, user the following command:

racadm fanoffset [-s <off|low|medium|high>]

Viewing front panel properties

To view the front panel properties:

1. In the left pane, click Chassis Overview → Front Panel.

2. On the Properties page, you can view the following:

• Power Button Properties

• KVM Properties

• Front Panel Indicators

Viewing KVM information and health status

To view the health status of the KVMs associated with the chassis, do any of the following:

Click Chassis Overview → Front Panel.

On the Status page, under the KVM Properties section, you can view the status and properties of a

KVM associated with the chassis. For more information, see the Online Help.

Viewing information and health status of temperature

sensors

To view the health status of the temperature sensors:

In the left pane, click Chassis Overview → Temperature Sensors.

The Temperature Sensors Status page displays the status and readings of the temperature probes on

the entire chassis (chassis and servers). For more information, see Online Help.