Users Guide

Configuring LED blinking using CMC web interface

To enable blinking for one, multiple, or all component LEDs:

• In the left pane, go to any of the following pages:

– Chassis Overview → Troubleshooting.

– Chassis Overview → Chassis Controller → Troubleshooting.

– Chassis Overview → Server Overview → Troubleshooting.

NOTE: Only servers can be selected on this page.

To enable blinking of a component LED, select the respective component , and then click Blink. To

disable blinking of a component LED, deselect the server, and then click Unblink.

Configuring LED blinking using RACADM

Open a serial/Telnet/SSH text console to CMC, log in, and type:

racadm setled -m <module> [-l <ledState>], where <module> specifies the module whose

LED you want to configure. Configuration options:

• server-n where n = 1-4 (PowerEdge FM120x4), and server-nx where n = 1–4 and x = a to b

(PowerEdge FC630).

• switch-1

• cmc-active

and <ledState> specifies whether or not the LED should blink. Configuration options:

• 0 — not blinking (default)

• 1 — blinking

Configuring CMC properties

You can configure CMC properties such as power budgeting, network settings, users, and SNMP and

email alerts using the web interface or RACADM commands.

Configuring front panel

You can use the front panel page to configure:

• Power button

• KVM

Configuring power button

To configure the chassis power button:

1. In the left pane, click Chassis Overview → Front Panel → Setup.

2. On the Front Panel Configuration page, under the Power Button Configuration section, select the

Disable Chassis Power Button option, and then click Apply.

The chassis power button is disabled.