Reference Guide

Description Tests LDAP configuration and operation, and reports success as each stage
of the authentication process proceeds. After successful completion, this
command prints the CMC privileges assumed by the specified <username>.
If a failure occurs, the command stops with an error message that displays
the required corrective action. Use the optional -d switch to obtain
additional diagnostic information, as needed.
Synopsis
testfeature -f ldap -u <username> -p <password> [-d
<diagnostic-message-level>]
testtrap
Description Tests the RAC’s SNMP trap alerting feature by sending a test trap from CMC to
a specified destination trap listener on the network.
To use this subcommand, you must have the Test Alerts permission.
NOTE: Before you execute the testtrap subcommand, make sure that
the specified index in the RACADM cfgAlerting group is configured
properly.
Synopsis
racadm testtrap -i <index>
Input -i — Specifies the index of the trap configuration to be used for the test. Valid
values are from 1 to 4.
Example
Commands for the cfgIpmiPet group:
• Enable the alert
racadm config -g cfgIpmiPet -o cfgIpmiPetAlertEnable -i 1
• Set the destination e-mail IP address
racadm config -g cfgIpmiPet -o cfgIpmiPetAlertDestIpAddr
-i 1 192.168.0.110
• View the current test trap settings
racadm getconfig -g cfgIpmiPet -i <index>
where <index> is a number from 1 to 4.
traceroute
Description Traces the network path of routers that packets take as they are forwarded
from your system to a destination IPv4 address.
To use this subcommand, you must have the Administrator permission.
Synopsis
• racadm traceroute <IPv4 address>
• racadm traceroute 192.168.0.1
Input
racadm traceroute 192.168.0.1
91