Users Guide

chassisaction -- execute chassis or switch power-up/down/cycle or KVM powercycle
clrraclog -- clear the CMC log
clrsel -- clear the System Event Log (SEL)
cmcchangeover -- Changes the redundant state of the CMC from active to standby and vice versa
config -- modify CMC configuration properties
LEDs on a module
...
setniccfg -- modify network configuration properties
setractime -- set the time on the CMC
setslotname -- sets the name of the slot in the chassis
setsysinfo -- set the chassis name and chassis location
sslcertview -- display a CA/server certificate in the CMC
sslcsrgen -- generate a certificate CSR from the CMC
testemail -- test CMC email notifications
testtrap -- test CMC SNMP trap notifications
l racadm ? getsysinfo
getsysinfo -- display general CMC and system information
Usage:
getsysinfo [-d] [-c] [-A]
-d : show cmc information
-c : show chassis information
-A : do not show headers or labels
arp
Descripción
MuestralatabladelProtocoloderesolucióndedirecciones(ARP).EstatablaalmacenalaasignacióndenúmerosIPadireccionesMACdelastarjetasde
interfaz de red en el chasis.
Ejemplo
l racadm arp
AddressHWtypeHWaddressFlagsMaskIface
143.166.152.3ether00:07:84:A7:CE:BCCeth0
143.166.152.2ether00:07:84:7B:9F:FCCeth0
143.166.152.1ether00:00:0C:07:AC:0ACeth0
143.166.152.113 ether 00:15:C5:48:9C:1D C eth0
chassisaction
Descripción
Ejecutaunaaccióndeencendidoenelchasis,iKVMounservidor.
Uso
racadm chassisaction [-m <módulo>] <acción>
Opciones
TablaA-1 describe las opciones del subcomando chassisaction.
Tabla A-1.Opcionesdelsubcomandochassisaction
NOTA: Para utilizar este subcomando debe contar con privilegios de Administrador.
NOTA: Para utilizar este subcomando, debe contar con privilegios de Administrador de control del chasis.
Opción
Descripción
-m <módulo>
Especificaelmóduloenelquedebeejecutarselaacción.El<módulo> puede estar representado por una de las siguientes opciones: