User's Manual

Using the RACADM Command Line Interface 91
Command updates for CMC 1.20
The following commands have been updated for the CMC 1.20 release:
• chassisaction
–
-d and -w deprecated
–
nongraceshutdown added
When I use the RACADM
subcommands, I get errors that I do not
understand.
You may encounter one or more of the
following errors when using RACADM:
• Local error messages — Problems such
as syntax, typographical errors, and
incorrect names.
Example:
ERROR: <message>
Use the RACADM help subcommand
to display correct syntax and usage
information.
• CMC-related error messages —
Problems where the CMC is unable to
perform an action. Also might say
"racadm command failed."
Ty p e
racadm gettracelog for debugging
information.
While I was using remote RACADM, the
prompt changed to a ">" and I cannot get
the "$" prompt to return.
If you type a double quotation mark (") in
the command, the CLI will change to the
">" prompt and queue all commands.
To return to the "$" prompt, type
<Ctrl>–d.
I tried using the following commands and
received an error saying "Not Found":
$ logout
$ quit
The logout and quit commands are not
supported in the CMC CLI interface.
Table 4-3. Using the Serial and RACADM Commands: Frequently
Asked Questions (continued)
Question Answer