User's Manual

Installing and Setting Up the CMC 47
Navigating in the LCD Screen
The right side of the LCD panel contains five buttons: four arrow buttons
(up, down, left, and right) and a center button.
• To move between screens , use the right (next) and left (previous) arrow
buttons. At any time while using the Configuration Wizard, you can
return to a previous screen.
•
To scroll through options on a screen , use the down and up arrow buttons.
•
To select and save an item on a screen and move to the next screen, use the
center button.
For more information about using the LCD panel see "Using the LCD Panel
Interface" on page 423.
Using the LCD Configuration Wizard
1 If you have not already done so, press the chassis power button to turn
it on.
The LCD screen displays a series of initialization screens as it powers up.
When it is ready, the
Language Setup screen displays.
2 Select your language using the down arrow button, and then press the
center button.
The
Enclosure screen displays with the following question: "Configure
Enclosure?"
3 Press the center button to continue to the CMC Network Settings screen.
4 Select your network speed (10Mbps, 100Mbps, 1Gbps, or Auto) using the
down arrow button.
NOTE: The Network Speed setting must match your network configuration for
effective network throughput. Setting the Network Speed lower than the
speed of your network configuration increases bandwidth consumption and
slows network communication. Determine whether your network supports the
above network speeds and set it accordingly. If your network configuration
does not match any of these values, Dell recommends that you use Auto
Negotiation (the Auto option) or refer to your network equipment
manufacturer.
Press the center button to continue to the next CMC Network Settings
screen.