User's Manual

Troubleshooting and Recovery 291
NOTE: The commands in steps 2–6 will overwrite any existing settings configured
for the index you specify (1–4). To determine whether an index has previously
configured values, type: racadm getconfig -g cfgTraps -i <index>. If the index is
configured, values will appear for the cfgTrapsAlertDestIPAddr and
cfgTrapsCommunityName objects.
To test an event trap for an alert destination:
racadm testtrap -i <
index >
where <index> is a value 1–4 representing the alert destination you want to
test. If you are unsure of the index number, type:
racadm getconfig -g cfgTraps -i < index >
Configuring Email Alerts
When the CMC detects a chassis event, such as an environmental warning or
a component failure, it can be configured to send an email alert to one or
more email addresses.
Table 11-1 provides an overview of the events that trigger email and SNMP
alerts. For information on SNMP alerts, see "Configuring SNMP Alerts" on
page 286.
You can add and configure email alerts using the Web interface or RACADM.
Using the Web Interface
NOTE: To add or configure email alerts, you must have Chassis Configuration
Administrator privilege.
1 Log in to the CMC Web interface.
2 Select Chassis in the system tree.
3 Click the Alert Management tab. The Chassis Events page appears.
4 Enable alerting:
a Select the check boxes of the events for which you want to enable
alerting. To enable all events for alerting, select the
Select All check
box.
b Click Apply to save your settings.
5 Click the Email Alert Settings sub-tab. The Email Alert Destinations
page displays.