User's Manual

290 Troubleshooting and Recovery
4 Enable traps alerting by typing:
racadm config -g cfgTraps -o cfgTrapsEnable 1 -i
<
index >
where <index> is a value 1–4. The index number is used by the CMC to
distinguish up to four configurable IP destinations for traps alerts.
5 Specify a destination IP address to receive the traps alert by typing:
racadm config -g cfgTraps -o
cfgTrapsAlertDestIPAddr
<IP address> -i < index >
where <IP address> is a valid IP address, and <index> is the index
value you specified in step 4.
6 Specify the community name by typing:
racadm config -g cfgTraps -o cfgTrapsCommunityName
<community name> -i < index >
where <community name> is the SNMP community to which the
chassis belongs, and
<index> is the index value you specified in steps 4
and 5.
You can configure up to four destination IP addresses to receive traps alerts.
To add more IP addresses, repeat steps 2–6.
Hardware Log Failure 0x4000
Hardware Log Warning 0x8000
Server Absent 0x10000
Server Failure 0x20000
KVM Absent 0x40000
KVM Failure 0x80000
IOM Absent 0x100000
IOM Failure 0x200000
Firmware mismatch 0x400000
Table 11-2. Event Traps Filter Masks (continued)
Event Filter Mask Value