User's Manual

Using the CMC Web Interface 113
NOTE: If you have two CMCs (primary and standby) on the chassis, and they are
both connected to the network, the standby CMC automatically assumes the
network settings in the event of failover of the primary CMC.
1 Log in to the Web interface.
2 Click the Network/Security tab.
3 Configure the CMC network settings described in Table 5-7.
4 Click Apply Changes .
To configure IP range and IP blocking settings, click the Advanced Settings
button (see "Configuring CMC Network Security Settings" on page 118).
To refresh the contents of the Network Configuration page, click Refresh.
To print the contents of the Network Configuration page, click Print.