Manualshelf

Users Guide

ManualsBrandsDell ManualsActive System ManagerChassis Management Controller Version 1.10 for Dell PowerEdge FX2
131132133134135136137138139140
Viewing I/O Module FCoE Session Information Using Web
Interface
You can view the FCoE session information for Dell PowerEdge M I/O Aggregator using the CMC web
interface. To do this:
1. Go to Chassis Overview → I/O Module Overview.
All the IOMs (1–6) appear in the expanded list.
2. Click the IOM (slot) you want to view. Click Properties → FCoE.
The FCoE I/O Module page specific to the IOM slot is displayed.
3. In the Select Port drop-down, select the required port number for the selected IOM and click Show
Sessions. The selected option retrieves the FCoE session information for the switch, and present it to
the user as a table.
The FCoE Session Information section displays the FCoE session information for the switch.
NOTE: The I/O Aggregator also displays the active FCoE sessions when the switch is using the
protocol.
Resetting IOM to Factory Default Settings
You can reset IOM to the factory default settings using the Deploy I/O Modules page.
NOTE: This feature is supported on PowerEdge M I/O Aggregator IOM only. Other IOMs including
MXL 10/40GbE are not supported.
To reset the selected IOMs to factory default settings using the CMC Web interface:
1. In the system tree, go to I/O Module Overview and click Setup or expand I/O Module Overview in
the system tree, select the IOM, and click Setup.
The Deploy I/O Modules page displays the IOM(s) that are powered on.
2. For the required IOM(s), click Reset.
A warning message is displayed.
3. Click OK to continue.
Updating IOM Software Using CMC Web Interface
You can update the IOM software by selecting the required software image from a specified location. You
can also rollback to an earlier software version.
NOTE: This feature is supported only on Dell PowerEdge I/O Aggregator.
To update the IOM Infrastructure device software, in the CMC Web interface:
1. Go to Chassis Overview → I/O Module Overview → Update.
The IOM Firmware Update page is displayed. Alternatively, go to any of the following
• Chassis Overview → Update.
• Chassis Overview → Chassis Controller → Update.
134