Reference Guide

NOTE: Chassis name is a maximum of 64 non-extended ASCII

characters.

Example

racadm setchassisname dellchassis-1

The chassis name was set successfully.root

setflexaddr

Description Enables or disables FlexAddress on a particular slot or fabric.

To use this subcommand, you must have the Chassis Configuration

Administrator privilege.

If the fabric type is determined to be Infiniband, the operation is canceled and

the command returns an error. If the FlexAddress feature is not activated, the

command returns an error.

NOTE: The server must be turned off to change the slot state. All servers

must be turned off to change the fabric state. The MAC/WWN addresses

must be managed locally (not by an external console) to use this

command.

Synopsis

racadm setflexaddr [-i <slot#> <state>][-f <fabricName>

<state>]

< slot# > = 1 to 4

< fabricName > = A1 or A2

< state > = 0 or 1

where 0 is disable and 1 is enable.

Input

• -i <slot#> <state> — Enables or disables FlexAddress for the specified slot.

• -f <fabricName> <state> — Enables or disables FlexAddress for the

specified fabric.

Example

• racadm setflexaddr -i 1 0

Slot 1 FlexAddress state set successfully

• racadm setflexaddr -f A 1

Fabric A FlexAddress state set successfully

• racadm setflexaddr -f idrac 1

setled

Description Sets the state (blinking or not blinking) of the LED on the specified module.

To blink or unblink the chassis, I/O modules or the CMC, you must have the

Debug Administrator privilege on CMC. To enable the servers to blink or