Reference Guide

• Reset servers 1 and 3.
racadm racreset -m server-1 -m server-3
racresetcfg
Description Resets CMC configuration to factory default settings.
NOTE: To use this, you must have the Chassis Administrator privilege.
Synopsis
racadm racresetcfg [-m <module>] [-c <feature>]
Input
• -m : <module> — Must be one of the following values:
– chassis — default state, if -m is not specified.
– server-n, where n=1–4
– switch-n, where n=1–2
• -c : <feature> — Must be one of the following values:
– ad — Reset Active Directory properties to the default value. The
default setting is “disabled”.
– pcap — Reset Power Cap properties to the default value.
– flex — Reset FlexAddress properties to the default value. The default
setting is “enabled”.
– NOTE: The –c option is valid with only <module=chassis>.
Example
• Perform reset of configuration data to defaults for server-1 module
racadm racresetcfg -m server-1
• Perform reset of power cap feature.
racadm racresetcfg -c pcap
• Perform reset of configuration data to default for switch-1 module
racadm racresetcfg -m switch-1
racresetpcie
Description Resets the PCIe server mapping in the chassis to factory defaults.
NOTE:
• To use this subcommand for CMC, you must have the Chassis
Administrator privilege.
• This command cannot run successfully, if any blade server is
powered on.
Synopsis
racadm racresetpcie
remoteimage
Description Connects, disconnects, or deploys a media file on a remote server.
70