Reference Guide

ManualsBrandsDell ManualsActive System ManagerChassis Management Controller Version 1.10 for Dell PowerEdge FX2

• cmc.alert.audit

• cmc.alert.audit.lic

• cmc.alert.audit.warning

• cmc.alert.audit.lic.critical

Input

• get - Displays the list of event filter settings.

• set - Configures the actions and notifications for a given event filter

configuration.

• -c - Alert descriptor of the specific event filter.

• -n - The notification to be sent when the event occurs. Valid values are

all, snmp, ipmi, email, or none. You can append multiple notifications

separated by a comma. You cannot enter the values all or none with

other notifications.

• -r - Event generation interval. This is applicable only to the temperature

statistics subcategory - tmps. You can use this option as a stand-alone or

with -n .

NOTE: If both event generation interval and notifications are

configured and there is an error while configuring the notifications, the

event generation interval is not set. The valid values are from 0–365. 0

disables the event generation.

Example

• Display all available event filter configurations:

racadm eventfilters get -c cmc.alert.all

• Display eventfilter configurations for a specific category. For example,

audit:

racadm eventfilters get -c cmc.alert.audit

• Display eventfilter configurations for a specific subcategory. For example,

licensing under the audit category:

racadm eventfilters get -c cmc.alert.audit.lic

• Display eventfilter configurations for a specific severity. For example,

warning under the audit category:

racadm eventfilters get -c cmc.alert.audit.warning

• Display eventfilter configurations for a specific severity and subcategory.

For example, a severity of warning in the subcategory licensing under

audit category:

racadm eventfilters get -c cmc.alert.audit.lic.warning

• Clear all available alert settings:

racadm eventfilters set -c cmc.alert.all -n none

• Configure using subcategory as a parameter. For example, all

configurations under the licensing subcategory in the audit category are

assigned poweroff as action and all notifications are enabled:

racadm eventfilters set -c cmc.alert.audit.lic -n all

• Configure using subcategory and severity as parameters. For example, all

Information events under the licensing subcategory in the audit category

are assigned poweroff as action and all notifications are disabled:

racadm eventfilters set -c cmc.alert.audit.lic.info -

n none

• Configure the event generation interval for temperature statistics:

racadm eventfilters set -c

cmc.alert.system.tmps.warning -r 10