User's Manual

86 Using the RACADM Command Line Interface
Troubleshooting
Table 4-3 lists common problems related to remote RACADM.
Table 4-3. Using the Serial and RACADM Commands: Frequently Asked Questions
Question Answer
After performing a CMC reset (using the
RACADM racreset subcommand), I issue
a command and the following message is
displayed:
racadm
<subcommand>
Transport: ERROR: (RC=-1)
What does this message mean?
You must wait until the CMC completes
the reset before issuing another
command.
When I use the RACADM
subcommands, I get errors that I do not
understand.
You may encounter one or more of the
following errors when using RACADM:
• Local error messages — Problems such
as syntax, typographical errors, and
incorrect names.
Example:
ERROR: <message>
Use the RACADM help subcommand
to display correct syntax and usage
information.
• CMC-related error messages —
Problems where the CMC is unable to
perform an action. Also might say
"racadm command failed."
Ty p e
racadm gettracelog for debugging
information.
While I was using remote RACADM, the
prompt changed to a ">" and I cannot get
the "$" prompt to return.
If you type a double quotation mark (") in
the command, the CLI will change to the
">" prompt and queue all commands.
To return to the "$" prompt, type
<Ctrl>–d.