User's Manual

RACADM Subcommands 295
• racadm feature -s
Feature = FlexAddress
Date Activated = 8 April 2008 - 10:39:40
Feature installed from SD card SN = 01122334455
featurecard
NOTE: To use this subcommand, you must have Chassis Configuration
Administrator privilege.
Description
Verifies proper SD card installation and displays SD card status. The table
below lists the status messages returned by the command.
Table A-6. Status Messages Returned by featurecard -s Command
Status Message Actions
No feature card inserted. Check the CMC to verify that the SD card
was properly inserted. In a redundant CMC
configuration, make sure the CMC with the
SD feature card installed is the active CMC
and not the standby CMC.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: The feature card is
bound to this chassis
No action required.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: The feature card is
bound to another chassis,
svctag = ABC1234, SD card
SN = 01122334455
Remove the SD card; locate and install the SD
card for the current chassis.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: The feature card is not
bound to any chassis
The feature card can be moved to another
chassis, or can be reactivated on the current
chassis. To reactivate on the current chassis,
enter
racadm racreset until the CMC
module with the feature card installed
becomes active.