User's Manual

144 Using the CMC Web Interface
Use the following steps to view FlexAddress server information:
1
Log in to the Web interface (see "Accessing the CMC Web Interface" on
page 87).
2 Expand Servers in the system tree. All of the servers (1–16) appear in the
expanded
Servers list.
3 Click the server you want to view. The Server Status page displays.
4 Click the Setup tab, and the FlexAddress sub-tab. The FlexAddress status
page is displayed. This page allows you to view the WWN configuration
and MAC addresses for the selected server.
The status page presents the following information:
FlexAddress Enabled Displays whether the FlexAddress
feature is enabled or disabled for the
particular slot.
Current State Displays the current FlexAddress
configuration:
• Chassis-Assigned - selected slot
address is chassis assigned using the
FlexAddress. The slot-based
WWN/MAC addresses remain the
same even if a new server is installed.
•
Server-Assigned - server uses the
server-assigned address or the default
address embedded into the controller
hardware.
Power State Displays the current power status of the
servers; values are: On, Powering On,
Powering Off, Off, and N/A (if a server
is not present).
BIOS Version Displays the current BIOS version of the
server module.
Location Displays the location of the
Input/Output (I/O) module in the
chassis by group number (A, B, or C)
and slot number (1 or 2). Slot names:
A1, A2, B1, B2, C1, or C2.