Owner's Manual

file:///T|/htdocs/SOFTWARE/smdrac3/cmc/cmc1.0/en/readme/CMC_README.TXT[10/26/2012 2:32:07 PM]
Network/Security tab->Services sub-tab of the CMC user interface in
localized languages does not list the Telnet Port legal values.
(179080)
* The help for the Slot Names page located in the Chassis-> Servers ->
Setup->Slot Names sub-tab of the CMC user interface in localized
languages does not list the rules for the slot names, which are:
(a) The beginning of the string cannot be Switch-, Fan-, PS-, KVM,
DRAC/MC-, Chassis and Housing-Left/Right/Center, which are case
insensitive.
(b) ASCII characters between 32 and 126 are allowed, but excludes 34 (").
(c) Server-n, where n is 1 to 10, is not allowed except that Server-n
is allowed for the n slot, which is case insensitive. Server-0n is
different from Server-n, like Server-02 is different from Server-2.
Therefore Server-2 is not allowed for any slot except the second one
but Server-02 can be set in any slot. (178014)
(d) Maximum allowed characters for the Slot Name is 15. (181364)
* The help for the Server Status page located in the Chassis-> Servers ->
Server 1-16 -> Properties tab->Status sub-tab of the CMC user interface
in localized languages does not list the Slot Name, Present properties.
It also has a reference to I/O module instead of servers under Health ->
Informational section. (179718)
* The help for the Chassis Power Management page located in the Chassis->
Power Management tab->Control sub-tab of the CMC user interface in
localized languages refers to Power Off System as equivalent to pressing
the power button when the power is "ON". This is not accurate since this
action performs a graceful shutdown of the chassis and if any of the modules
do not shutdown within the time period, they will remain on. (181069)
* The help for the Identify page located in the Chassis-> Troubleshooting
tab->Identify sub-tab of the CMC user interface in localized languages
mentions the note:
To blink or unblink the servers, you must have Log in to iDRAC privilege
on the iDRAC of these servers.
This is missing Server Administrator privilege on CMC and should be:
To blink or unblink the servers, you must have Server Administrator privilege
on CMC or Log in to iDRAC privilege on the iDRAC of these servers.
(175595)
* The help for the User Configuration page located in the Chassis->
Network/Security tab-> Users sub-tab-> click User ID number of the
CMC user interface in localized languages does not have the Super User
listed under the CMC User Privileges section. The super user privilege is
currently reserved for future use. (180734)
* The help for the Power Budget Status page located in the Chassis->
Power Management tab-> Budget Status sub-tab of the CMC user interface in
localized languages describes the Standby DC Power Capacity as:
Indicates the amount of power (in watts) available to be provided by Power