Owner's Manual

Using the LCD Panel Interface 369
LCD Module and Server Status Information
The tables in this section describe status items that are displayed on the front
panel LCD for each type of component in the chassis.
Warning Mem Redun Gain: Memory sensor,
redundancy degraded (<DIMM
Location>) was asserted
Memory redundancy is down
graded but not lost.
Critical PCIE Fatal Err: Critical Event
sensor, bus fatal error was asserted
Fatal error is detected on the PCIE
bus.
Critical Chipset Err: Critical Event sensor,
PCI PERR was asserted
Chip error is detected.
Warning Mem ECC Warning: Memory
sensor, transition to non-critical
from OK (<DIMM Location>)
was asserted
Correctable ECC errors have
increased from a normal rate.
Critical Mem ECC Warning: Memory
sensor, transition to critical from
less severe (<DIMM Location>)
was asserted
Correctable ECC errors have
reached a rate.
Critical System Board POST Err: POST
sensor for System Board, POST
fatal error <additional error
information> was asserted
See Hardware Service Manual for
BIOS POST addition error
information.
Table C-9. CMC Status
Item Description
Name/Location Example: CMC1, CMC2
Error Messages If no error then "No Errors" is shown; otherwise error messages
are listed, critical errors first, then warnings.
IP Address Only shows on active CMC.
MAC Address Only shows on active CMC.
Firmware Version Only shows on active CMC.
Table C-8. Server Status Screen for M600/M605 (continued)
Severity Message Cause