Owner's Manual

Power Management 199
5 Select one of the following Power Control Operations by clicking its radio
button:
•
Power On System — Turns on the system power.
•
Power Off System — Turns off the system power.
•
Reset CMC — Resets the CMC without powering off (warm reboot).
(This option is disabled if the CMC is already powered off).
NOTE: This action only resets the CMC. No other components are affected.
• Power Cycle System — Power off, then reboot (cold boot) the system.
6 Click Apply . A dialog box appears requesting confirmation.
7 Click OK to perform the power management action (for example, cause
the system to reset).
Using RACADM
Open a Telnet/SSH text console to the CMC, log in, and type:
racadm chassisaction -m chassis <
action >
where < action > is powerup, powerdown, powercycle, or reset.
Executing Power Control Operations on an IOM
You can remotely execute a reset or power cycle on an individual IOM.
NOTE: To perform power management actions, you must have Chassis Control
Administrator privilege.
Using the Web Interface
1 Log in to the CMC Web interface.
2 Select I/O Modules . The I/O Modules Status page displays.
3 Click the Power Management tab. The Power Control page displays.
4 Select the operation you want to execute ( reset or power cycle ) from the
drop-down menu beside the IOM in the list.
5 Click Apply . A dialog box appears requesting confirmation.
6 Click OK to perform the power management action (for example, cause
the IOM to power cycle).