Messages Reference Guide

ManualsBrandsDell ManualsComputersChassis Management Controller Version 1.0 for PowerEdge VRTX

621

622

623

624

625

626

627

628

629

630

Trap/EventID FALSE

LCD Message No LCD message display defined.

Initial Default. LC Log

Filter

Visibility

IPMI Alert SNMP

Alert

LC Log LCD Power Off Power

Cycle

Reset

FALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE

RDU8502

Message CMC

arg1

cannot go standby since the other CMC is not present or healthy.

Arguments

•

arg1 =

slot number

Detailed

Description

For failover to occur, the standby CMC needs to be present, at the same version as the primary

and healthy. During failover, the active CMC resets and the standby CMC becomes active. This

message is logged when the standby CMC is absent, unhealthy or at a different firmware

version.

Recommended

Response Action

Check the status of the standby CMC and make sure the firmware version matches the primary

CMC. Then reseat the CMC and retry the operation. If the issue persists, contact your service

provider.

Category Audit

SubCategory RDU = Redundancy

Severity Severity 3 (Informational)